18650 battery holder with PCB module designed for making 3.7V Li-Ion 18650 battery pack in 1 series 4 Parallel configuration with 5.0A rate limited by PCB installed
Battery pack watt-hour = 3.7V x cell capacity
Each holder is design to hold 4 x standard (Flat top) 18650 cell (Do NOT use button top cell)!
Protection
PCB (5.0A limited, Manufacture part# PCM-L01P04-377) installed on front surface for protect the battery from
Overcharge (>4.2V)
Over discharge ( <2.5 V)
Over drain ( >5.0 Amp)
Short circuits
Terminal
2.6" long 20AWG for charge/discharge terminal
Material
Polypropylene
Color
Black
Dimension (LxWxH)
84mm(3.3") x 80mm(3.14") x 18.6mm(0.7")
Weight
1.0Oz (30 grams)
Temperature
Storage temperature: 25'C (77F, Room Temperature)
Max Operate temperature: 80'C (176F)
Warning
This battery holder is designed for standard 18650 (flat top) battery only!
Please don't remove PCB installed on battery holder.
This battery holder is for only 1S4P battery pack. Please don't combine battery holder for any series / parallel connection.
After insert battery(ies), must connect to charger to enable the pcb. Otherwise, you will get "no" output from pcb!
Li-Ion battery may be exploded if misuse. We are not responsible for any damages or losses caused by misusing
Always charge battery with attention. Battery pack shall be placed on a fire-proof place to avoid any accident
Please check battery polarity before plug battery into device. Never make wrong polarity connection.
Contact:Ms.Apple Tel:+852-6876 5661 E-mail:info@sunbesthk.com Wechat/Skype:sunbesthk88
Copyright 2022 Sun Best (Hong Kong) International Co., Limited All rights reserved.